TATC TIPS FOR MX TALON SYSTEMS
THE ULTIMATE IN VERSATILITY
CHOOSE THE CORRECT GEOMETRY
Metcal TATC tip cartridges are available in the following tip geometries and in two standard temperature ranges (500 Series and 600 Series).
Metcal's unique design means that a wide range of components can be removed by a small range of tips. You can remove 28-pin SOIC's, tantalums, and 0603 chip caps without changing tips. Where it is possible, a beveled edge is provided to improve versatility. When you use this feature, make sure that all leads are contacted during removal. See illustration below.
CHOOSE THE PROPER SERIES
Each Metcal cartridge is designed to deliver high power in response to loads. For this reason, you can often work with a Metcal cartridge at a temperature lower than with a conventional iron. 500 Series cartridges will work well for most applications.
TIP CARTRIDGES CAN BE INSERTED THREE WAYS
Measurement "A" (Span) refers to the minimum and maximum distance between two cartridges when used together in the Talon® in the three possible configurations.
| Part Number | Description |
|---|---|
| TATC-x01 | Fine Point Tip .015" (0.4mm) |
| TATC-x02 | Blades Tip .25" (6.35mm) |
| TATC-x03 | Blades Tip .62" (15.75mm) |
| TATC-x04 | Blades Tip .81" (20.57mm) |
| TATC-x05 | TSOP 32 Tip |
| TATC-x06 | Blades Tip 1.1" (27.94mm) |
| TATC-x08 | Angled Viper Tip .05" (1.27mm) |
x=5 for 500 Series, 6 for 600 Series
*Denotes a corner bevel for small components.
Please note: TATC tip cartridges are for use with the Talon only
